This kit includes all the major components you need to refresh the front and rear trunk of your car.
Front Trunk Seal
New reproduction of the front trunk seal. This has been made from a softer rubber for a better fit and seal and matches the factory profile perfectly.
914.511.901.10, 914 511 901 10, 914-511-901-10, 91451190110
Bulkhead Seal for Front/Rear Trunk
New reproduction of the front and rear trunk bulkhead seal. This isolates the fuel tank from the front trunk and the rear trunk from the engine compartment while keeping moisture out.
This comes in one length and will need to be trimmed to fit the front bulkhead. A box cutter or x-acto knife can be used to easily cut off the excess length.
914.512.315.10, 914 512 315 10, 914-512-315-10, 91451231510
914.511.902.10, 914 511 902 10, 914-511-902-10, 91451190210
Wiring Harness Tape
New 60 m (180') roll of 12 mm cloth tape for re-wrapping the wiring harness.
Front Trunk Wire Pull Guide Tube
New production of the guide tube in the front trunk. As plastic becomes brittle over time this tube cracks allowing the wire to flex excessively making the front trunk difficult to open.
914.511.231.10, 914 511 231 10, 914-511-231-10, 91451123110
Wire Pull Cable for Porsche 914
New reproduction wire pull cable for use with the front trunk or engine compartment latches. Includes a threaded end stud for direct installation into existing hardware.
914.511.091.10, 914 511 091 10, 914-511-091-10, 91451109110
Front Trunk Drain Tube
New production drain tube for the front trunk with a squared off edge for a stronger base.
911.025.612.00, 911 025 612 00, 911-025-612-00, 91102561200
Adjustable Rubber Stop for Trunk and Engine Deck Lid
New reproduction adjustable rubber stop for the engine deck lid and the front and rear trunk lids.
999.703.036.50, 999 703 036 50, 999-703-036-50, 99970303650
Front Trunk Nose Panel Plug for Porsche 914
New reproduction of the plugs for the front trunk. This part plugs the holes the holes in the front trunk that were in the cars until late 1975. These have been made from silicone for a better seal.
914.559.252.10, 914 559 252 10, 914-559-252-10, 91455925210
Expansion Tank Gasket
New reproduction of the rubber seal beneath the expansion tank. Made from solvent resistant rubber to prevent deterioration.
914.201.893.10, 914 201 893 10, 914-201-893-10, 91420189310
Fuel Sending Unit Sealing Ring
New reproduction sealing ring for the VDO fuel sending unit.
477.919.133, 477 919 133, 477-919-133, 477919133
License Plate Wire Grommet
This is a new reproduction wire grommet. The part number is used in several areas of the car for several different shapes. The part we have made is specifically to solve the leaking trunk issue and may not be the part you are looking for on different applications. This part has a tighter fit than the factory part creating a better seal.
111.971.911.A, 111 971 911 A, 111-971-911-A, 111971911A
Rear Trunk Lock Gasket
New reproduction lock gasket. This has been made from silicone to form a better water seal and prevent moisture from seeping into the trunk.
914.512.193.10, 914 512 193 10, 914-512-193-10, 91451219310
Rear Trunk Lock Guide Bushing
New reproduction guide bushing for the rear trunk lock spring. Previously only available as part of a complete assembly from the factory.
914.512.041.10, 914 512 041 10, 914-512-041-10, 91451204110
Rear Main Trunk Seal
New reproduction of the rear main trunk seal made with internal aluminum clips to prevent internal rusting. This seal runs along the outer edge of the opening and seals the trunk area when closed.
914.512.317.10, 914 512 317 10, 914-512-317-10, 91451231710
Rubber Roof Holder Set
New reproduction of the rubber support mount in the trunk for the targa top. This has been made from solid rubber with stainless steel internal bushings and includes all new stainless hardware for installation.
914.559.015.10, 914 559 015 10, 914-559-015-10, 91455901510
914.559.016.10, 914 559 016 10, 914-559-016-10, 91455901610
Upper Rear Trunk Roof Holder
New reproduction of the plastic roof holder that goes in the back of the rear trunk. The roof clips onto this while being stored in the rear trunk.
914.559.219.10, 914 559 219 10, 914-559-219-10, 91455921910
Rear Trunk Roof Latch Cup
New reproduction cups for the roof latches when stored in the rear trunk. Installs in the openings between the rear bulkhead and rear trunk.
914.559.227.10, 914 559 227 10, 914-559-227-10, 91455922710
Rear Shock Tower Rubber Covers (Cap)
New reproduction of the rubber cap for the top of the rear shock tower. This installs installs in the rear trunk and protects the targa top from being damaged by the struts while it is stowed away. Also referred to as the "witch hat."
914.559.281.10, 914 559 281 10, 914-559-281-10, 91455928110
Rear Trunk Torsion Bar Roller
New reproduction of the spring rollers for the rear trunk hinge.
914.512.263.11, 914 512 263 11, 914-512-263-11, 91451226311
Rear Trunk Lid Torsion Bar Clamp Set of 4
Set of new reproduction clamps for securing the ends of the rear torsion bar to the body. This also includes 8 lock washers and nuts for installation.
Includes
914.512.219.10, 914 512 219 10, 914-512-219-10, 91451221910
900.076.010.02, 900 076 010 02, 900-076-010-02, 90007601002
900.027.014.01, 900 027 014 01, 900-027-014-01, 90002701401
Front and Rear Trunk Hinge Shoulder Bolt for 914
New reproduction of the shoulder bolt, used for mounting the trunk hinges to the inner fender.
914.512.191.10, 914 512 191 10, 914-512-191-10, 91451219110
Tail Light Gasket Set for 914
New reproduction foam gasket with an adhesive backing for the tail light housing.
Fits to:
914.631.403.12, 914 631 403 12, 914-631-403-12, 91463140312
914.631.404.12, 914 631 404 12, 914-631-404-12, 91463140412
Tail Light Lens to Housing Seal Set for 914
New reproduction Neoprene foam cord to seal the tail light lens to the housing.
Fits to:
914.631.949.10, 914 631 949 10, 914-631-949-10, 91463194910
914.631.950.10, 914 631 950 10, 914-631-950-10, 91463195010