Fabspeed Valved Maxflo Exhaust for Corvette C8 E-Ray (2024+)

Choose a more restrained or more assertive exhaust note on an E-Ray equipped with the matching original NPP valved system. This stainless cat-back incorporates an X-pipe and the selected quad-tip finish. Based in Fort Washington, Pennsylvania, Fabspeed Motorsport designs exhaust, intake and ECU-tuning products for Porsche and other sports cars. Development includes evaluation on a dynamometer, on the road and at the racetrack.

Technical Details

• For the matching original E-Ray NPP-valved layout.
• 3-inch T304L/321 stainless tubing and flexible bellows.
• Amorphous silica-fiber heat protection with 321 stainless outer wrapping.
• Includes two described AFM simulator plugs; verify the exact vehicle electronics and installation procedure.
• Fabspeed reports approximately 20 lb less than its original NPP baseline.
• No cutting or welding specified.
• A valve relearn may be required with suitable diagnostic equipment after installation; investigate any fault rather than assuming none can occur.
• Covered by the Fabspeed Lifetime Warranty, subject to its terms and exclusions.

Use restrictions

Retain required emissions equipment and confirm the exact vehicle market and installation requirements. Catalyst or filter changes require application-specific approval; no universal road legality or fault-light guarantee is implied.

With over 20 years of parts experience, PMB Performance can help check the application. Share your VIN and photos or references for the component being replaced before ordering if the match is uncertain.

Fitment & Compatibility

Use the application details below together with the original component and any existing modifications.