Original BMW Steel Oil Pan Gasket for BMW 3 Series, 5 Series, X3, X5, Z3, and Z4 (1991–2008)

Built on a steel carrier with a rubber sealing bead around its edge, the Original BMW oil pan gasket 11-13-1-437-237 seals the oil pan to the bottom of the inline-six engine in 3 Series, 5 Series, X3, X5, Z3, and Z4 models. BMW calls it "Gasket Steel," and it weighs 139 g. BMW has made this version since September 1997. It replaces the earlier gasket 11-13-9-065-875, and BMW rates the change as exchangeable retrospectively. A leak usually starts when the rubber bead fails, and fixing it early keeps the leak from getting worse.

Original BMW Parts carry a 24-month parts warranty.

An oil pan gasket sits between the engine block and the oil pan and keeps oil inside the sump. One gasket covers BMW's M50, M52, M54, M56, S50, S52, and S54 engine families, from the early-1990s E34 525i to the E46 M3 and Z4 M. The number also cross-references to 11-13-1-720-519. Removing the pan is enough to damage a used gasket, so fit a new one whenever the pan comes off. For the joint at the rear of the pan, BMW recommends Drei Bond 1209 sealant (07-58-9-062-376) on the edge where the engine block meets the rear main seal flange. Order the sealant along with the gasket.

Technical Details

• Manufacturer: BMW (Original BMW Part)
• Part number: 11-13-1-437-237
• BMW part name: Gasket Steel (oil pan gasket)
• Construction: steel with a rubber perimeter bead
• Weight: 139 g (0.3 lb)
• Production start: September 1997
• Replaces 11-13-9-065-875 (exchangeable retrospectively)
• Cross-reference: 11-13-1-720-519
• Quantity: one gasket, sold individually
• Warranty: 24 months

Installation & Tuning Notes

Drain the oil and clean both sealing faces before fitting the new gasket. Tighten the pan bolts to BMW's torque value in an even sequence, because uneven tightening can warp the pan and cause a leak.

Common Questions

Can I reuse my old gasket?
Fit a new one. Removing the pan can damage the old gasket enough to leak.

Do I need sealant?
Yes, at the rear. BMW calls for Drei Bond 1209 where the block meets the rear main seal flange.

PMB can add the sealant to your order.

Fitment & Compatibility

Use the fitment table below to confirm year, make, model, submodel, and any notes tied to your exact vehicle. Pay close attention to engine, chassis, position, and option-specific details before ordering. With over 20 years of parts and fitment experience, PMB Performance can match this to your VIN.