Turn your Grand Cherokee's engine bay into a showpiece with a genuine carbon fiber overlay built to outlast the competition.
This fan shroud overlay is handcrafted in the USA from premium carbon fiber and finished with a high gloss UV resistant gel coat that resists yellowing, fading, and cracking far longer than the automotive clear coats most competitors use. It drops directly over your existing factory fan shroud, so there is no cutting, trimming, or fabrication involved, just a clean surface and a strong adhesive bond.
The gel coat finish is exceptionally hard and holds a mirror like shine that actually improves with regular polishing. If it ever picks up a scratch or a gouge from road debris, it can be wet sanded, re buffed, or filled with clear gel coat to look like new again, something fiberglass and lower grade carbon fiber pieces simply cannot do.
Fitment
Fits 2005 to 2010 Jeep Grand Cherokee WK generation models, including Laredo, Limited, Overland, SRT8, and Special Edition trims. Confirm your factory fan shroud shape matches before ordering.
Specs
| Part Number | BOAW-FS05JPGC-C |
| Material | Genuine carbon fiber with UV resistant high gloss gel coat finish |
| Fitment | 2005 to 2010 Jeep Grand Cherokee WK, Laredo, Limited, Overland, SRT8 |
| Installation | Overlay with included high strength 3M adhesive tape |
| Construction | Handcrafted in the USA |
| Maintenance | Wax monthly with pure carnauba wax, compatible with ceramic coatings and PPF |
What's Included
- 1 x Carbon Fiber Fan Shroud Overlay (BOAW-FS05JPGC-C)
- High strength 3M adhesive tape, pre applied for installation
FAQ
Does this replace my factory fan shroud or go over it?
This is an overlay piece, it adheres directly to your existing factory fan shroud rather than replacing it, so the stock part stays in place underneath.
What is the part number for this fan shroud overlay?
The part number is BOAW-FS05JPGC-C, and it is molded to match the WK generation Grand Cherokee shroud shape used from 2005 to 2010.
How do I keep the gel coat finish looking new?
A monthly wax with pure carnauba wax keeps the gel coat from drying out, and it is safe to run ceramic coatings or PPF over it for extra long term protection.
Installation Instructions
- Remove the factory fan shroud from the vehicle, or access it in place if removal is not required.
- Thoroughly clean the mounting surface with isopropyl alcohol or a wax and grease remover to eliminate all wax, oil, and residue.
- Dry fit the overlay onto the factory shroud to confirm alignment before exposing the adhesive.
- Peel back a small section of the 3M adhesive backing and set one edge of the overlay in place.
- Gradually remove the remaining backing while pressing the overlay down, working outward to prevent air pockets.
- Apply firm, even pressure across the entire surface, using a plastic squeegee if available, to lock in a secure bond.
- Let the adhesive cure for 24 hours before washing the vehicle, then reinstall the shroud assembly if it was removed.