034Motorsport Direct Injection Head Port Cleaning Tool for Audi and Volkswagen (2005–2024)

The 034Motorsport Direct Injection Head Port Cleaning Tool is a billet aluminum fixture for carbon cleaning on direct injection Audi and Volkswagen engines. It seals against an open intake port so you can media blast carbon off the port walls and the backs of the intake valves. Direct injection engines spray fuel straight into the cylinder, so no fuel washes over the intake side. Over time, carbon builds up inside the intake ports and on the valves, and those deposits cost the engine power and efficiency. Removing them by hand is slow, awkward, and expensive. The tool has two ports. The small port takes a media blasting wand, and the large port connects to a shop vacuum hose. Suction from the vacuum holds the tool against the intake port, which leaves both hands free to work the blasting wand.

034Motorsport parts sold by PMB Performance carry a 24-month warranty.

034Motorsport machines the tool from billet 6061-T6 aluminum and gives it a clear anodized, corrosion-resistant finish. The vacuum port fits a standard 40mm (1 1/2 inch) shop vacuum hose. The wand port accepts media blast wands up to 10mm (3/8 inch) in diameter. Spent blasting media goes straight into the shop vacuum, so there is little to no clean-up afterward. The tool is made in the United States. 034Motorsport was founded by Javad Shadzi in 2005, and it designs and builds its Audi and Volkswagen products at its Performance Facility in Fremont, California.

Technical Details

• Manufacturer: 034Motorsport
• Part number: 034-108-Z054
• Part name: direct injection head port cleaning tool
• Material: billet 6061-T6 aluminum, clear anodized
• Vacuum port: fits a standard 40mm (1 1/2 inch) shop vacuum hose
• Wand port: accepts media blast wands up to 10mm (3/8 inch) in diameter
• Made in the United States
• Sold as one cleaning tool
• Warranty: 24 months

Installation & Tuning Notes

Before you place the tool, rotate the crankshaft until the intake valves in that port are closed. Then set the tool on the intake port and switch on the shop vacuum. The vacuum pulls the tool tight against the head. Blast through the small port, and the vacuum draws the media away as you work. Close the intake valves in the next port before you move the tool there.

Common Questions

Does the tool come with a blaster or vacuum?
No. The tool is sold by itself, so you supply the shop vacuum, the media blaster, and the blasting media.

Will my blasting wand fit the tool?
The wand port accepts wands up to 10mm (3/8 inch) in diameter.

What holds the tool in place while I blast?
Suction from the shop vacuum holds it against the intake port. You do not need to clamp or hold it.

PMB sells 034Motorsport tooling for owners who do their own carbon cleaning at home or in the shop.

Fitment & Compatibility

Check the fitment table below for the Audi and Volkswagen models this tool covers. Contact PMB with your VIN, and we will confirm the fit before you order.